Welcome to Shenzhen Bogao Marking Technology Co. Ltd.
Service Hotline:
138-0885-1890

After sales service

Contact Us

You are here:Home >> After sales service... >> FAQ

FAQ

Single face labeling machine adjustment related details

Time:2019-10-17 Views:240
      In the process of the operation of the single side labeling machine, as users of the single side labeling machine, should be understanding and mastering the use of the related equipment and related fault solution, then bo high shenzhen label vendors would small make up a simple introduce about the single side labeling machine for everyone in the process of using relevant adjustment details, hope that through the following can use a help to you later.
      Generally speaking, the adjustment of single-sided labeling machine includes the following four parts, which are respectively: the adjustment of the bottle star wheel, the bottle star wheel, the bottle screw rod, the adjustment of the marking station, the adjustment of the brush device and the adjustment of the label box, among which:
      1. Adjustment of the feeding star wheel, feeding star wheel and feeding screw: when adjusting the feeding star wheel and feeding screw, the bottle head of the marking machine shall prevail. First, adjust the feeding wheel. When the head of the bottle presses down on the bottle, adjust the feeding wheel so that the bottle is in the middle of the groove of the feeding wheel. Adjustment of bottle feeding screw: take the bottle feeding star wheel as the criterion. When the bottle is in the middle of the groove of the bottle feeding star wheel, adjust the screw so that the screw feeding side is close to the bottle but no displacement is generated. Adjust the star wheel of the bottle: when the bottle head is just lifted, the single-side automatic labeling manufacturer quote, adjust the star wheel so that the bottle is in the middle of the groove of the star wheel.
      2. Adjustment of label box: the center line of the label box, the center axis of the label station and the label paper are tangent, and the center axis of the label board is aligned at three points. Adjust the tangent of the label board and the label paper (0 distance), and then move the label box closer to 1mm ~ 2mm. The gap between the marking paper in the marking box and the layering on both sides should be between 0.8mm ~ 1mm. The gap is too large, which causes the marking paper to shift in the marking box, leading to inclined marking. The gap is too small, which will cause poor marking. Adjust the position of the grab hook of the label box: the grab hook of upper and lower, left and right is on the same vertical plane and evenly laboring on the label paper, so that the scratch can be successfully achieved. Label supply roller adjustment: in the absence of a label, the label pressure plate can be pressed to the first front of the label box and the label is installed, the label hook refers to the label nearby cannot be crushed.
Copyright © 2019 Shenzhen Bogao Marking Technology Co. Ltd. All Rights Reserved. 粤ICP备19100904号   
Web Design—Tiandixin